Master board

Easy connectable

Connect your hardware with X-plane

The SimulConn Master board is acting as an interface between X-plane on your PC and the SimulConn I/O boards.
Connect the Master board to the PC with a USB cable, and upload SimVimX/RealSimControl firmware to the onboard Arduino.

Many possibilities

Modular approach

Master board has 8 extension connections. Each connectable to an Extension board in a specific part of the cockpit.

Each extension board connector holds 7 Arduino connector pins. The connecting Extension board can accommodate 7 I/O cards.

12v are connected directly to the Master board and is distributed to the IO boards by the attached ribbon cables.

Read more about the connections here:

Test points are easily accessible for troubleshooting purposes.

 

Master board currently comes to two revisions:
– Rev2: Attached Arduino MEGA
– Rev3: Embedded Arduino MEGA

Dimensions:
Rev2: 117x97mm (4.60×3.82in)

Click here for technical information

 

The SimulConn Master board is acting as an interface between X-plane on your PC and the SimulConn I/O boards, using the SimVimX add-on.

Connect the Master board to the PC with a USB cable, and upload SimVimX/RealSimControl firmware to the onboard Arduino.

The Master board has 8 extension connections. Each connectable to an Extension board in a specific part of the cockpit.

Each extension board connector holds 7 Arduino connector pins. The connecting Extension board can accommodate 7 I/O cards.
12v is connected directly to the Master board and is distributed to the IO boards by the attached ribbon cables.
Read more about the connections here: Pin mappings
Test points are easily accessible for troubleshooting purposes.

The Master board comes with some pre-soldered SMD components.
For the Extension connections, we recommend IDC connectors, and for Stepper/Servo/LCD connections we recommend JST XH connectors. But you can mount the connectors of your choice or even solder cables directly to the board.

Design yourself

Connect your way

The Master board comes with some pre-soldered SMD components.

For the Extension connections we recommend IDC connectors, and for Stepper/Servo/LCD connections we recommend JST XH connectors. But you can mount the connectors of your choice or even solder cables directly to the board.

Get in touch

For more information about SimulConn, contact me using below form.